:  Apr 22, 2004








. Disconnect the battery ground cable.

.
  : Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.

. Remove the RH front wheel.

. Remove the engine undershield.

. Remove the engine compartment upper RH heat shield.
  Remove the screw.




. :
  The heatshield consists of 3 parts.

Remove the upper suspension arm and brake line heat shields for access.
  Remove the 3 nuts.
  Remove the 3 bolts.




. Disconnect the height sensor link arm.

.
  : Use a wrench on the hexagon provided to prevent the ball joint rotating.

Remove the stabilizer bar link nut.

.
  : To prevent the wheel knuckle falling outwards and disconnection of the halfshaft inner joint, support the wheel knuckle.

Loosen the upper arm retaining nut.



. Using the special tool, release the upper arm ball joint.
  Remove and discard the retaining nut.




. Release the brake hose from the upper arm.



. Tie the upper suspension arm aside for access.

. Support the engine.

. Raise the engine.
  Remove the nut.

. Remove the engine front mount.
  Remove and discard the 2 bolts.




. Clean the component mating faces.

. Install the engine front mount.
  Tighten the bolts to 45 Nm (33 lb.ft), then a further 60 degrees.

. Lower the engine onto the mount.
  Tighten the nut to 90 Nm (66 lb.ft).

. Remove the engine support.

. Secure the brake hose to the upper arm.
  Tighten the bolt to 23 Nm (17 lb.ft).

. Connect the upper arm and wheel knuckle.
  Remove the cable tie securing the upper arm.
  Install a new nut and tighten to 70 Nm (52 lb.ft).

. Secure the stabilizer bar link.
  Tighten the nut to 115 Nm (85 lb.ft).

. Connect the height sensor link arm.

. :
  The heatshield consists of 3 parts.

Install the upper suspension arm and brake line heat shields.
  Install the bolts.
  Install the nuts.

. Install the engine compartment upper RH heat shield.
  Install the screw.

. Install the engine undershield.

. Install the front wheel.
  Tighten the wheel nuts to 140 Nm (103 lb.ft).